I mainly play music through the Tuner or Turntable. The last connection i tried was a 2-male RCA to 1-male cable connected the 2-male to the LINE-IN ports on subwoofer and the other end 1-male rca to the Sub-Out and no bass The Gallien-Krueger Backline 600 Bass Head can handle the wear and tear of touring. Next i connected double ended RCA to the Subwoofer then the other end to REC Out MD / Tape and the sub works but not sure if this connection is ok to use or will it cause more harm down the line and damage the sub? Is REC Out still considered line-level/no amplification? I did notice the gain on the sub does not match up to the volume control from the receiver so i am constantly turning the gain knob up/down Status light on the sub is green/active but nothingĭSP = Arena, Jazz, Stadium, Disco, Theater Gallien-Krueger Backline 600 2-Channel 300-Watt Bass Amp Head As low as 22/month Gordon LaSalle Music. GALLIEN KRUEGER BACKLINE 600 OPERATION MANUAL Service Manual download, schematics, eeprom, repair info for electronics experts GALLIEN KRUEGER BACKLINE 600 OPERATION MANUAL Type: (PDF) Size 3.0 MB Category AUDIO USER MANUAL If you get stuck in repairing a defective appliance download this repair information for help. There are specific settings for crossovers which are pre-programmed settings Active EQ, Speaker EQ, DSP, Stereo. Has a pair of Line-in ports and an additional port labeled LF.įirst i connected an LFE rca to the LFE port then to the Sub-out, went into settings put Sub On, changed my tower speakers to small and no bass at all when cranking up the gain. My subwoofer which is a JBL135 with no cross-over knob only Gain. Have not done a factory reset yet on the Kenwood receiver Sub-out on Kenwood VR-6060 NOT Working with powered subwoofer Can someone please help me! I have troubleshooted but maybe I am missing something. With active electronics, set all controls on the bass to the If you have aass with passive electronics make sure that the.
0 Comments
Leave a Reply. |